Lenco IR-3000 User Manual download pdf (Page 6)

Storing a radio station in a preset via the panel control:

To store the current radio station to one of the 12 available presets:

(1) Press the “preset” button.

(2) Select which preset number to store the station to by turning the dial to highlight the desired

location, then holding the "select" button for a few seconds.

For example, to store to preset 1:

(1) press the” preset” button. The following will show on the LCD display:

(2) Turn the dial until Preset 1 is showing.

(3) Hold the “Select” button for about 3 seconds, until the screen displays:

To select a preset station while the radio is playing, press the “preset” button, turn the dial until

the desired preset number is displayed, and then press “select."

For example: to play Radio A from Preset 1, press “preset” button, turn the dial until the unit

displays”<1:A>”, then press the “select” button.

Note: some presets are stored with default content and you can overwrite them with your

favourite station.

Storing a radio station in a preset via the front remote control:

To store a preset, while listening to the desired station press the STORE button and

then the number of the preset you would like to save it to. Allow 2 seconds for the

selection to register. The LCD will then show <Assigned to preset #>.

To tune to a preset station, press the RECALL button and the preset number for the desired

station. Once you have saved a station to one of the presets, you can tune to it by pressing

RECALL button and then the number where the station is stored.

Setting the CLOCK

Note: If you make a mistake at any point, press BACK button to go back to the previous screen

1. Press the BACK button.

2. Rotate the dial until the display says<Configure>.

- 5 -

Configure

Assigned to preset 1

1 2 3 4 5 6 7 8 9 10 11 ... 17 18

No comments

Lenco IR-3000 User Manual Page 6