Lenco IR-3000 User Manual download pdf (Page 13)

Configure Menu

1. Press the SELECT button.

Note: If you make a mistake at any point, press the BACK button to go back to the previous

screen.

2. Rotate the dial until ‘Configure’ is displayed

3. Press the SELECT button.

4. Rotate the dial until the display shows the option you want.

5. Press the SELECT button to choose the option shown on the display. The options are

explained below.

Enables you to configure your radio network settings, scan again for a connection to another

wireless network, or to manually configure the network parameters. This is useful if you take the

Internet radio to another building to use.

Once the radio has established a certain type of connection to the network, then this type of

connection will remain in use while the radio is on.

You can enable or disable the WIFI low signal warning under the Signal Warning Menu.

Displays the version numbers of the Internet radio software and hardware.

Use this option to download new firmware for the radio from the Reciva portal on the Internet. If

there is new firmware available, the radio will prompt you whether or not you want to download it.

Note, at this stage, you can press the BACK button to cancel the firmware upgrade. A firmware

upgrade may take several minutes. The radio may be permanently damaged if you switch off the

power while the upgrade is taking place.

Allows you to change the display language.

Puts all the settings back to their default as they were when the radio left the factory. If you

perform a factory reset on your radio you will lose all your presets and your wireless network

connection.

This will display a key that can be used to register the radio on the Reciva Customer portal.

<Clock>

Use this option to set the time, see ’”Setting the clock’’.

Use this option to set the sleep timer

Selecting this option will alter the Internet radio’s backlight values.

1. After select the ‘Backlight’ menu item, three menu modes are available: ‘Inactive’, ‘Active’ and

‘Standby’. These three states are explained below:

The radio sets to ‘Inactive’ when there is no user activity for 30 seconds.

The ‘Active’ state is when there is user activity.

‘Standby’ is the state when the radio has been turned off

- 12 -

1 2 ... 8 9 10 11 12 13 14 15 16 17 18

No comments

Lenco IR-3000 User Manual Page 13