Lenco CR-334 Instruction Manual download pdf (Page 9)

2.) Set the ALARM selector switch for one or both alarms to the BUZZER position. The

appropriate ALARM 1 and/or ALARM 2 display will change from “OFF” to the selected wake

up time.

3.) At the selected wake up time the buzzer will sound. It will begin softly and gradually increase in

volume to wake you up. It will continue for one hour and then shut off automatically.

4.) To stop the buzzer sooner, press either the appropriate ALARM 1 or ALARM 2 button. The

buzzer will stop but the alarm remains set and will turn the buzzer on again at the same time on

the following day (depending on the Alarm Mode setting).

To stop the buzzer and turn on the radio immediately, press the RADIO ON/OFF button

instead of the ALARM 1 or ALARM 2 button.

5.) If you do not want the alarm to turn the buzzer on the following day, set the appropriate

ALARM selector to the “OFF” position. The respective alarm display will show “OFF”.

Radio and Buzzer Operation

You may also set one alarm for wake to radio and the other for wake to buzzer.

Just set the ALARM 1 and ALARM 2 selector switches to the desired positions.

Snooze/Repeat Alarm

After the alarm turns ‘On’ in the morning you can press the SNOOZE/SLEEP OFF button on the

top cabinet for approximately 9 extra minutes sleep. The snooze LED indicator flashes.

The alarm will stop for approximately 9 minutes and then comes ‘On’ again.

Touchless Snooze Control

You can also activate the Snooze alarm without physically touching the SNOOZE/SLEEP OFF

button. When the alarm sounds in the morning, just wave your hand in front of the WAVE

SENSOR on the front panel (see illustration) to activate the Snooze alarm.

The Touchless Snooze Control works by detecting body heat. For best results your hand should

be within 24 inches of the front right panel.

1 2 3 4 5 6 7 8 9 10 11 12 13

No comments

Lenco CR-334 Instruction Manual Page 9